In a balanced wheatstone bridge, if the position of detecor and source are interchanged, the bridge will still remain balanced. This interference can be drawn from

When the power transferred to the load is maximum, the efficiency of power transfer is

Answer - 50 %

Millman's theorem yields equivalent

A.Impdedance or ResistanceB. Current SourceC. Voltage SourceD. Voltage or Current Source

When a reisitors R is connected to a current source, it consumes a power of 18w. When the same R is connected to a voltage source having the same magnitude as the current source, the power absorbed by R is 4.5W. The magnitude of current source and the value of R are

Which of the following theorems is applicable for both linear and non linear circuits?

kirchhof's laws are valid for

1. Linear Circuits Only
2. Passive Time Invariant
3. Non Linear Circuits Only
4. Both Linear and Non Linear Circuit only

Ideal current source has zero

A) internal resistance
B) internal conductance
C) voltage at no-load
D) ripples

Three parallel resistive branch are connected across a dc supply. what will be the ratio of the branch currents I1:I2:I3 if the branch resistances are in the ratio R1:R2:R3::2:4:6?

A. 3:2:6
B. 2:4:6
C. 6:3:2
D. 6:2:4

Two resistors R1 and R2 give combined resistance of 4.5 ohm when in series and 1 ohm when in parallel the resistance are

A voltage source having an open circuit voltage of 100V and internal resistance of 50W is equivaent to a current source

Which of the following statements is correct? Nichol's chart is useful for detailed study and analysis of

The bode diagram approach is the most commonly used method for the analysis and synthesis of

A. Non Linear Feedback control system only
B. Linear Feedback Control System Only
C.Open Loop System Only
D. All of the above

For the equation s3-4s2+s+6=0 the number of roots in the left half of s-plane will be

The open loop transfer function of a unity feedback control system is given by G(S)=K(S+2)/s(s2+2s+2) the centroid and angles of root locus asymptotes are respectively

Which of the following is the most likely reason for large overshoot in a control system?

1. High Gain in a System
2. Presence of dead time delay in a system
3. High Positive Correcting Torque
4. High Retarding Torque

Given a unity feedback system with G(S)=K/s(S+4), the value of k for damping ratio of 0.5 is

The output of first order hold between two consecutive sampling instant is a

How can steady state eror in a system be reduced ?

A. By decreasing the type of system
B. By increasing system gain
C. By decreasing the static error constant
D. By increasing the input